Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM
RM37A0E _59 Vehicle Exterior _086901 WIPER / WASHER _0417921 WIPER AND WASHER SYSTEM C

WIPER / WASHER  WIPER AND WASHER SYSTEM  B1373  Lost Communication with Wiper System LIN BUS  


DESCRIPTION

The main body ECU (multiplex network body ECU) and rain sensor communicate via LIN communication. The main body ECU (multiplex network body ECU) stores this DTC if communication becomes abnormal.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory DTC Output from
B1373 Lost Communication with Wiper System LIN BUS
Detection condition:

Auxiliary battery voltage is 9.5 V or more


Malfunction Status:

A malfunction in the communication or LIN communication line between the main body ECU (multiplex network body ECU) and components of the wiper system occurs


Malfunction Time:

7 seconds or more 3 times consecutively


·

Main body ECU (multiplex network body ECU)

·

Harness or connector

·

Rain sensor


○ Main Body

WIRING DIAGRAM

E366415E08
0.167,1.25 0.615,1.49 0.448,0.24 10 false H42 5.104,1.24 5.417,1.438 0.313,0.198 10 false R4 0.167,1.417 3.25,1.667 3.083,0.25 10 false Main Body ECU (Multiplex Network Body ECU) 5.406,1.24 7.156,1.635 1.75,0.396 10 false Rain Sensor 2.667,0.5 2.823,0.698 0.156,0.198 10 false 3 4.417,0.5 4.573,0.698 0.156,0.198 10 false 3 4.635,0.698 5.052,0.896 0.417,0.198 10 false MPX 2.229,0.698 2.646,0.896 0.417,0.198 10 false LIN3 0.469,2.292 3.552,2.542 3.083,0.25 10 false : LIN Communication Line

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.


PROCEDURE

1.CHECK RAIN SENSOR
a.

Disconnect the R4 rain sensor connector.


b.

Clear the DTCs.

Body Electrical > Main Body > Clear DTCs
50002 123

c.

Turn the ignition switch to ON and wait for at least 10 seconds.


d.

Read the DTCs.

Body Electrical > Main Body > Trouble Codes
50001 123

Result:
Result Proceed to
Only DTC B1279 is output A
DTC B1373 is output B



A

B

2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) - RAIN SENSOR)
2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) - RAIN SENSOR)
a.

Disconnect the H42 main body ECU (multiplex network body ECU) connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H42-3 (LIN3) - R4-3 (MPX) Always Below 1 Ω
H42-3 (LIN3) or R4-3 (MPX) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR