83163
1.INSTALL NO. 1 COMBINATION METER MIRROR PLATE
Install the No. 1 combination meter mirror plate with the 7 screws.
83847
2.INSTALL NO. 1 COMBINATION SPEEDOMETER CUSHION
Clean the meter mirror sub-assembly surface.
Remove any remaining double-sided tape from the meter mirror sub-assembly.
Wipe off any tape adhesive residue with cleaner.
Remove the release paper from a new No. 1 combination speedmeter cushion.
After removing the release paper, keep the exposed adhesive free from foreign matter.
Install the No. 1 combination speedometer cushion as shown in the illustration.
| *a | Edge of Curved Surface | *b | Rib of Meter Mirror Sub-assembly |
|
Double-sided Tape | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | -5.0 to 5.0 mm (-0.197 to 0.197 in.) | B | 0 to 5.0 mm (0 to 0.197 in.) |