Home › Vehicle Interior › METER / GAUGE / DISPLAY › TRIP SWITCH
RM37A0E _58 Vehicle Interior _086889 METER / GAUGE / DISPLAY _0417953 TRIP SWITCH G

METER / GAUGE / DISPLAY  TRIP SWITCH  INSPECTION  


PROCEDURE

Hide 84975 1.INSPECT TRIP SWITCH

a.
E430766C01
1.302,4.229 1.563,3.917 false 1.667,4.25 1.771,3.917 false 2.271,4.25 2.208,3.917 false 0.094,0.083 0.406,0.24 0.313,0.156 10 false *a 1.188,4.25 1.5,4.448 0.313,0.198 10 false RV 1.552,4.25 1.865,4.448 0.313,0.198 10 false A/B 2.25,4.26 2.563,4.458 0.313,0.198 10 false E
*a Component without harness connected
(Trip Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 (RV) - 1 (E) Light control rheostat up switch pressed Below 1 Ω
Light control rheostat up switch not pressed 10 kΩ or higher
Light control rheostat down switch pressed 1.71 to 1.89 kΩ
Light control rheostat down switch not pressed 10 kΩ or higher
3 (A/B) - 1 (E) ODO/TRIP switch pressed Below 1 Ω
ODO/TRIP switch not pressed 10 kΩ or higher


If the result is not as specified, replace the trip switch.


b.
E430766C02
1.25,4.25 1.344,3.906 false 2.083,4.25 1.979,3.917 false 0.104,0.083 0.417,0.24 0.313,0.156 10 false *a 1.156,4.271 1.771,4.469 0.615,0.198 10 false ILL+ 2.021,4.271 2.635,4.469 0.615,0.198 10 false ILL-
*a Component without harness connected
(Trip Switch)


Illumination Inspection

i.

Apply auxiliary battery voltage to the trip switch and check that it illuminates.

OK:
Condition Specified Condition
Auxiliary battery positive (+) → Terminal 5 (ILL+)
Auxiliary battery negative (-) → Terminal 2 (ILL-)
Illuminates


If the result is not as specified, replace the trip switch.