81260A
1.INSPECT MAP LIGHT ASSEMBLY
Voltage Value Check
| *a | Component without harness connected
(Map Light Assembly) |
Measure the voltage in accordance with the following conditions with diode test mode selected.
As the circuit includes a diode, make sure that the polarity of each terminal is correct and diode test mode is selected before connecting the tester.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Tester positive (+) → 15 (RLMP)
Tester negative (-) → 3 (DOOR) |
Door linked switch on | 0.6V to 1V |
If the result is not as specified, replace the map light assembly.
Resistance Check
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 15 (RLMP) - 11 (GND) | Dome light switch on | Below 1 Ω |
If the result is not as specified, replace the map light assembly.
Illumination Inspection
Apply auxiliary battery voltage to the map light assembly and check that the lights illuminate.
| Measurement Condition | Condition | Specified Condition |
|---|---|---|
| Auxiliary battery positive (+) → 10 (+B1)
Auxiliary battery negative (-) → 11 (GND) |
Dome light switch off and map light switch LH on | Map light LH illuminates |
| Dome light switch off and map light switch RH on | Map light RH illuminates | |
| Map light switch LH and RH off and dome light switch on | Map light LH and RH illuminate | |
| Auxiliary battery positive (+) → 10 (+B1)
Auxiliary battery negative (-) → 3 (DOOR) |
Map light switch LH and RH off and door linked switch on | Map light LH and RH illuminate |
| Map light switch LH and RH off and door linked switch off | Map light LH and RH do not illuminate | |
| Auxiliary battery positive (+) → 10 (+B1)
Auxiliary battery negative (-) → 15 (RLMP) |
Map light switch LH and RH off | Map light LH and RH illuminate |
| Map light switch LH and RH on | Map light LH and RH do not illuminate |
| Measurement Condition | Condition | Specified Condition |
|---|---|---|
| Auxiliary battery positive (+) → 9 (ILLB)
Auxiliary battery negative (-) → 2 (LILL) |
Always | Switch illumination and shift lever illumination illuminate |
If the result is not as specified, replace the map light assembly.