When removing or installing the communication telematics box, use static electricity countermeasures SST (desktop anti-static mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).
STATIC ELECTRICITY COUNTERMEASURES SST
SST: Desktop antistatic mat set
Antistatic mat
Wristband
Wristband connection wire (No. 1 grounding wire)
Ground connection wire (No. 2 grounding wire)
PRECAUTIONS DURING REPLACEMENT
Precautions during procedures:
Before performing any procedures, touch an unpainted metal part or ground bolt of the vehicle to eliminate any static electricity.
To prevent damage to an electrical equipment, disconnect the battery power supply before installing and removing the electrical equipment.
Never touch the electronic parts of a printed wire board or the pins of an integrated circuit.
When performing procedures, do not allow clothing to come near or contact parts.
Wear SST (wristband) firmly on your wrist.
Connect SST (No. 2 grounding wire) and SST (antistatic mat) to an appropriate grounding point in the workspace and on the work table.
When working inside the vehicle:
Connect SST (No. 2 grounding wire) to the unpainted metal part of a grounded bolt, etc.
Connect SST (No. 1 grounding wire), SST (wristband) and SST (antistatic mat).
Always place the communication telematics box and its components on SST (anti-static mat).