Home › General › MAINTENANCE › BATTERY COOLING FILTER
RM37A0E _V1 General _086848 MAINTENANCE _0418116 BATTERY COOLING FILTER A

MAINTENANCE  BATTERY COOLING FILTER  INSTALLATION  


PROCEDURE

Hide G92DJ 1.INSTALL NO. 2 HV BATTERY INTAKE FILTER

a.

Engage the 2 claws to temporarily install the No. 2 HV battery intake filter to the No. 1 HV battery intake cover.


b.

Engage the claw to install the No. 2 HV battery intake filter to the No. 1 HV battery intake cover.


Hide G9239D 2.INSTALL NO. 1 HV BATTERY INTAKE COVER

a.

Engage the 2 guides to temporarily install the No. 1 HV battery intake cover to the No. 3 hybrid battery intake duct.


b.

Engage the claw to install the No. 1 HV battery intake cover to the No. 3 hybrid battery intake duct.


Hide 67926A 3.INSTALL REAR DOOR SCUFF PANEL LH

a.

Engage the 2 guides to temporarily install the rear door scuff panel LH.


b.

Engage the 4 claws to install the rear door scuff panel LH.


Hide 4. CLEAR DTC

HINT:

If the message "Maintenance Required for Traction Battery Cooling Parts See Owner's Manual" is displayed on the multi-information display, clean or replace the No. 1 HV battery intake filter, and clear the DTCs to reset the learning values even if no DTCs are output.

for 2WD: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for 2WD)>DTC CHECK / CLEAR

for 4WD/AWD: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for 4WD/AWD)>DTC CHECK / CLEAR