Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › 2020.02–2020.11
RM37A0E _58 Vehicle Interior _086892 SUPPLEMENTAL RESTRAINT SYSTEMS _0418174 AIRBAG SYSTEM D

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  OPERATION CHECK  


PRECAUTION FOR OPERATION CHECK


CAUTION:
C376913

Use the correct procedure to replace the airbag parts.



CHECK SRS WARNING LIGHT


a.
B519726

Primary check

i.

Turn the ignition switch to ON and check that the SRS warning light turns on.


ii.

Turn the ignition switch off. Wait for at least 2 seconds, and then turn the ignition switch to ON. Check that the SRS warning light illuminates for approximately 6 seconds while diagnosis of the airbag system is performed.

HINT:
·

If the SRS warning light remains on for more than approximately 6 seconds after the ignition switch is turned to ON, the airbag system may be malfunctioning.

·

If the SRS warning light occasionally turns on after the ignition switch has been ON for approximately 6 seconds, there may be an open, or short to +B or ground in the SRS warning light circuit.

·

If the SRS warning light illuminates after the ignition switch is turned off or to ACC, there may be a malfunction in the airbag sensor assembly power source circuit or combination meter assembly.

·

After the initial check, if the SRS warning light turns off and then on repeatedly, a drop in airbag sensor assembly power source voltage is occurring. The SRS warning light will turn off 10 seconds after the power source voltage returns to normal.






FUNCTION OF PASSENGER AIRBAG ON/OFF INDICATOR (w/ Airbag Cut Off Switch)


a.

Initial check

i.

Turn the ignition switch to ON.


ii.

The passenger airbag ON/OFF indicator comes on for approximately 4 seconds, then goes off for approximately 2 seconds.

C355684E03
4.865,3.385 7.01,3.969 2.146,0.583 10 false ON/OFF condition depends on the airbag cut off switch cylinder sub-assembly status result.* 0.448,0.438 1.427,0.865 0.979,0.427 10 false Ignition Switch 1.885,0.646 2.427,1.052 0.542,0.406 10 false OFF 1.885,0.26 2.479,0.552 0.594,0.292 10 false ON 1.885,1.854 2.427,2.26 0.542,0.406 10 false OFF 1.885,2.99 2.427,3.396 0.542,0.406 10 false OFF 1.885,1.469 2.375,1.729 0.49,0.26 10 false ON 1.885,2.604 2.333,2.875 0.448,0.271 10 false ON 3.531,1.167 4.021,1.427 0.49,0.26 10 false T1 3.531,2.302 4.021,2.563 0.49,0.26 10 false T1 4.542,1.167 5.031,1.427 0.49,0.26 10 false T2 4.542,2.313 5.031,2.573 0.49,0.26 10 false T2 0.094,1.573 1.854,2.104 1.76,0.531 10 false Passenger Airbag ON/OFF Indicator ("ON") 0.094,2.698 1.844,3.208 1.75,0.51 10 false Passenger Airbag ON/OFF Indicator ("OFF") 0.125,3.76 2.24,4.083 2.115,0.323 10 false T1: Approximately 4 seconds 0.125,4.104 2.26,4.427 2.135,0.323 10 false T2: Approximately 2 seconds 0.125,4.458 6.073,4.792 5.948,0.333 10 false *: The ON indicator illuminates for approximately 60 seconds and then turns off.


iii.

Approximately 6 seconds after the ignition switch is turned to ON, the passenger airbag ON/OFF indicator will indicate ON/OFF according to the airbag cut off switch cylinder sub-assembly condition as listed below.

Indicator Operation
Airbag Cut Off Switch Cylinder Sub-assembly Condition Passenger Airbag ON/OFF Indicator SRS Warning Light
ON Indicator OFF Indicator

*: The ON indicator illuminates for approximately 60 seconds and then turns off.

ON ON* OFF OFF
OFF OFF ON OFF
Switch failure OFF ON ON

HINT:

If the passenger airbag ON/OFF indicator does not operate as specified in the table according to the airbag cut off switch cylinder sub-assembly status and the SRS warning light is not illuminated, no DTC will be output. Therefore, perform troubleshooting for Trouble in Passenger Airbag ON/OFF Indicator.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>Trouble in Passenger Airbag ON/OFF Indicator





PASSENGER AIRBAG ON/OFF INDICATOR CHECK (w/ Airbag Cut Off Switch)


a.
B568069

Turn the ignition switch to ON.


b.

Check that the passenger airbag ON/OFF indicator ("ON" and "OFF") comes on for approximately 4 seconds, then turns off for approximately 2 seconds.

HINT:

Refer to the indicator operation table in Function of Passenger Airbag ON/OFF Indicator for the passenger airbag ON/OFF indicator operation when the ignition switch is turned to ON and approximately 6 seconds elapse.




INSPECT AIRBAG COMPONENTS


a.

Inspect the SRS parts in table below.

Component to Inspect Procedure
Horn button assembly
1.

Perform a diagnostic system check.

2.

Visually check for defects with the horn button assembly installed to the vehicle.

HINT:

The defects are as follows:

·

Cuts on the surface or in the grooves

·

Small cracks on the surface or in the grooves

·

Significant discoloration on the surface or in the grooves



OK:

No defects are found.


If any defects are found, replace the horn button assembly with a new one.


Lower No. 1 instrument panel airbag assembly
1.

Perform a diagnostic system check.

2.

Visually check for defects with the lower No. 1 instrument panel airbag assembly installed to the vehicle.

HINT:

The defects are as follows:

·

Cuts

·

Small cracks

·

Significant discoloration



OK:

No defects are found.


If any defects are found, replace the lower No. 1 instrument panel airbag assembly with a new one.


Instrument panel passenger airbag assembly
1.

Perform a diagnostic system check.

2.

Visually check for defects with the instrument panel passenger airbag assembly installed to the vehicle.

HINT:

The defects are as follows:

·

Cuts on the instrument panel safety pad sub-assembly around the instrument panel passenger airbag assembly

·

Small cracks on the instrument panel safety pad sub-assembly around the instrument panel passenger airbag assembly

·

Significant discoloration on the instrument panel safety pad sub-assembly around the instrument panel passenger airbag assembly



OK:

No defects are found.


If any defects are found, replace the instrument panel safety pad sub-assembly with a new one.


Curtain shield airbag assembly
1.

Perform a diagnostic system check.

2.

Visually check for defects with the curtain shield airbag assemblies installed to the vehicle.

HINT:

The defects are as follows:

·

Cuts on each pillar garnish or the roof headlining assembly around the curtain shield airbag assemblies

·

Small cracks on each pillar garnish or the roof headlining assembly around the curtain shield airbag assemblies

·

Significant discoloration on each pillar garnish or the roof headlining assembly around the curtain shield airbag assemblies



OK:

No defects are found.


If any defects are found, replace each pillar garnish or the roof headlining assembly with a new one.


Front seat airbag assembly
1.

Perform a diagnostic system check.

2.

Visually check for defects with the front seat airbag assemblies installed to the vehicle.

HINT:

The defects are as follows:

·

Scratches, broken or frayed threads on the surface of the front seatback assembly around the front seat airbag assemblies

·

Small cracks in the front seatback assembly around the front seat airbag assemblies

·

Significant discoloration on the front seatback assembly around the front seat airbag assemblies



OK:

No defects are found.


If any defects are found, replace the separate type front seatback pad or separate type front seatback cover with a new one.


Front seat outer belt assembly
1.

Perform a diagnostic system check.

2.

Visually check for defects with the front seat outer belt assemblies installed to the vehicle.

HINT:

The defects are as follows:

·

Cuts

·

Small cracks

·

Significant discoloration



OK:

No defects are found.


If any defects are found, replace the front seat outer belt assembly with a new one.


Rear seat outer belt assembly
1.

Perform a diagnostic system check.

2.

Visually check for defects with the rear seat outer belt assemblies installed to the vehicle.

HINT:

The defects are as follows:

·

Cuts

·

Small cracks

·

Significant discoloration



OK:

No defects are found.


If any defects are found, replace the rear seat outer belt assembly with a new one.


Airbag sensor assembly
1.

Perform a diagnostic system check.


Front airbag sensor
Side airbag sensor assembly
Rear airbag sensor
Harness and connector