The ECM communicates with each sensor and ECU via CAN communication.
If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| U010087 | Lost Communication with ECM/PCM "A" Missing Message | When the dynamic radar cruise control system is operating, a communication malfunction between the skid control ECU (brake actuator assembly) and ECM is detected for approximately 1 second or more. | CAN communication system | Cruise Control |
| U010487 | Lost Communication with Cruise Control Module Missing Message | When the ignition switch is ON and the dynamic radar cruise control system is operating, a communication malfunction between the forward recognition camera and ECM is detected for approximately 1 second or more. | CAN communication system | Cruise Control |
| U012287 | Lost Communication with Vehicle Dynamics Control Module Missing Message | When the ignition switch is ON and the dynamic radar cruise control system is operating, a communication malfunction between the skid control ECU (brake actuator assembly) and ECM is detected for approximately 3 seconds or more. | CAN communication system | Cruise Control |
Clear the DTCs.
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Check for DTCs.
DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG