The forward recognition camera communicates with each sensor and ECU via CAN communication.
If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| U010087 | Lost Communication with ECM/PCM "A" Missing Message | When the dynamic radar cruise control system is operating, a communication malfunction between the ECM and forward recognition camera is detected for 5 seconds or more. | CAN communication system | Radar Cruise2 |
| U012587 | Lost Communication with Multi-axis Acceleration Sensor Module Missing Message | When the vehicle speed is 1 km/h (1 mph) or more, a communication error between the forward recognition camera and airbag sensor assembly continues for 5 seconds or more. | CAN communication system | Radar Cruise2 |
| U012687 | Lost Communication with Steering Angle Sensor Module Missing Message | When the ignition switch is ON for 2 seconds or more, a communication error between the forward recognition camera and steering sensor continues for 5 seconds or more. | CAN communication system | Radar Cruise2 |
| U012987 | Lost Communication with Brake System Control Module Missing Message | When the ignition switch is ON for 2 seconds or more, a communication error between the forward recognition camera and skid control ECU (brake actuator assembly) continues for 5 seconds or more. | CAN communication system | Radar Cruise2 |
| U015587 | Lost Communication with Instrument Panel Cluster (IPC) Control Module Missing Message | When the ignition switch is ON for 2 seconds or more, a communication error between the forward recognition camera and combination meter assembly continues for 5 seconds or more. | CAN communication system | Radar Cruise2 |
| U110687 | Lost Communication with Electric Parking Brake Module Missing Message | When the ignition switch is ON for 2 seconds or more, a communication error between the forward recognition camera and skid control ECU (brake actuator assembly) continues for 5 seconds or more. | CAN communication system | Radar Cruise2 |
Clear the DTCs.
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Check for DTCs.
DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG