If the forward recognition camera cannot verify the vehicle information sent from the skid control ECU (brake actuator assembly), the forward recognition camera stores DTC U031851.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| U031851 | Software Incompatibility with Brake System Control Module Not Programmed | The vehicle information sent from the skid control ECU (brake actuator assembly) cannot be verified by the forward recognition camera. | Forward recognition camera | Forward recognition camera |
When replacing the forward recognition camera, replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle and a DTC may be stored.
If the forward recognition camera has been replaced with a new one, it is necessary to perform forward recognition camera adjustment.
Forward recognition camera adjustment can be performed by using either One Time Recognition or Sequential Recognition.
One Time Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (ONE TIME RECOGNITION)
Sequential Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (SEQUENTIAL RECOGNITION)
Replace the forward recognition camera with a new one.
Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT