Home › Engine / Hybrid System › CRUISE CONTROL › FRONT CAMERA SYSTEM › 2020.02–2020.11
RM37A0E _51 Engine / Hybrid System _086858 CRUISE CONTROL _0418321 FRONT CAMERA SYSTEM C

CRUISE CONTROL  FRONT CAMERA SYSTEM  U032251  Software Incompatibility with Body Control Module Not Programmed  


DESCRIPTION

The forward recognition camera receives vehicle information from the main body ECU (multiplex network body ECU) via CAN communication.

DTC U032251 is stored when the forward recognition camera cannot confirm the vehicle information from the main body ECU (multiplex network body ECU).

DTC No. Detection Item DTC Detection Condition Trouble Area
U032251 Software Incompatibility with Body Control Module Not Programmed The forward recognition camera cannot confirm the vehicle information from the main body ECU (multiplex network body ECU). Forward recognition camera

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.

·

If the forward recognition camera has been replaced with a new one, be sure to perform forward recognition camera adjustment.

HINT:

Forward recognition camera adjustment can be performed by using either One Time Recognition or Sequential Recognition.

One Time Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (ONE TIME RECOGNITION)

Sequential Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (SEQUENTIAL RECOGNITION)




PROCEDURE

1.CHECK FOR DTCs (HEALTH CHECK)
a.

Check DTCs.


b.

Turn the ignition switch off.


OK:

DTCs are not output by any system other than the front camera system (Front Recognition Camera) and dynamic radar cruise control system (Radar Cruise 2).


Result:
Proceed to
OK
NG



OK

2.REPLACE FORWARD RECOGNITION CAMERA

NG

GO TO DTC CHART

2.REPLACE FORWARD RECOGNITION CAMERA
a.

Replace the forward recognition camera with a new one.

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>REMOVAL


b.

Perform forward recognition camera adjustment.

HINT:

Forward recognition camera adjustment can be performed by using either One Time Recognition or Sequential Recognition.

One Time Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (ONE TIME RECOGNITION)

Sequential Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (SEQUENTIAL RECOGNITION)



Result:
Proceed to
NEXT



NEXT

END