When a communication malfunction is detected between the forward recognition camera and an ECU or sensor, a DTC is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U010087 | Lost Communication with ECM/PCM "A" Missing Message | 3 seconds or more after the ignition switch is turned to ON, while the vehicle is being driven at 5 km/h (4 mph) or more and the lane control system is on, a communication error is detected between the ECM and forward recognition camera for approximately 5 seconds or more. | CAN communication system |
| U012587 | Lost Communication with Multi-axis Acceleration Sensor Module Missing Message | While the vehicle is being driven at 5 km/h (4 mph) or more and the lane control system is on, a communication error is detected between the yaw rate sensor*1 or airbag sensor assembly*2 and forward recognition camera for approximately 5 seconds or more. | CAN communication system |
| U012687 | Lost Communication with Steering Angle Sensor Module Missing Message | 3 seconds or more after the ignition switch is turned to ON, while the lane control system is on, a communication error is detected between the steering sensor and forward recognition camera for approximately 5 seconds or more. | CAN communication system |
| U012987 | Lost Communication with Brake System Control Module Missing Message | 3 seconds or more after the ignition switch is turned to ON, while the lane control system is on, a communication error is detected between the No. 2 skid control ECU (brake actuator assembly)*1 or skid control ECU (brake actuator assembly)*2 and forward recognition camera for approximately 5 seconds or more. | CAN communication system |
| U013187 | Lost Communication with Power Steering Control Module Missing Message | 3 seconds or more after the ignition switch is turned to ON, while the lane control system is on, a communication error is detected between the power steering ECU (rack and pinion power steering gear assembly) and forward recognition camera for approximately 5 seconds or more. | CAN communication system |
| U015587 | Lost Communication with Instrument Panel Cluster (IPC) Control Module Missing Message | 3 seconds or more after the ignition switch is turned to ON, while the lane control system is on, a communication error is detected between the combination meter assembly and forward recognition camera for approximately 50 seconds or more. | CAN communication system |
| U029387 | Lost Communication with Hybrid Powertrain Control Module Missing Message | 3 seconds or more after the ignition switch is turned to ON, while the vehicle is being driven at 5 km/h (4 mph) or more and the lane control system is on, a communication error is detected between the hybrid vehicle control ECU and forward recognition camera for approximately 5 seconds or more. | CAN communication system |
*1: for HV Model
*2: for Gasoline Model
Clear the DTCs.
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Check for DTCs.
DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
for HV Model: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for HV Model)>HOW TO PROCEED WITH TROUBLESHOOTING
for Gasoline Model: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for Gasoline Model)>HOW TO PROCEED WITH TROUBLESHOOTING