Home › Engine / Hybrid System › CRUISE CONTROL › ROAD SIGN ASSIST SYSTEM
RM37A0E _51 Engine / Hybrid System _086858 CRUISE CONTROL _0418323 ROAD SIGN ASSIST SYSTEM U

CRUISE CONTROL  ROAD SIGN ASSIST SYSTEM  TERMINALS OF ECU  


CHECK FORWARD RECOGNITION CAMERA


B472992E19
2.073,0.833 2.458,1.042 0.385,0.208 2.146,0.854 2.458,1.052 0.313,0.198 10 false R5

NOTICE:
·

DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the GTS once the inspection has been completed.

·

Do not apply excessive force to the forward recognition camera connector.



a.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Terminal Description Condition Specified Condition
R5-7 (IGB) - R5-10 (GND) Power source Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V
R5-10 (GND) - Body ground Ground Always Below 1 Ω


b.

Check for pulses according to the value(s) in the table below.

HINT:

If the waveform is not similar to that shown in the illustration, a malfunction of a CAN bus line, terminating resistor, or the forward recognition camera is suspected.


Terminal No. (Symbol) Terminal Description Condition Specified Condition
R5-5 (CA1P) - R5-10 (GND) CAN communication signal Ignition switch ON Pulse generation
(See waveform 1)
R5-6 (CANH) - R5-10 (GND) CAN communication signal Ignition switch ON Pulse generation
(See waveform 1)
R5-11 (CA1N) - R5-10 (GND) CAN communication signal Ignition switch ON Pulse generation
(See waveform 2)
R5-12 (CANL) - R5-10 (GND) CAN communication signal Ignition switch ON Pulse generation
(See waveform 2)

i.
A438764N02
3.031,1.406 3.344,1.698 0.313,0.292 10 false GND

Waveform 1

Item Content
Tester Connection
·

Between R5-5 (CA1P) and R5-10 (GND)

·

Between R5-6 (CANH) and R5-10 (GND)


Tool Setting 1 V/DIV., 10 μs./DIV.
Condition Ignition switch ON

HINT:

The waveform varies depending on the CAN communication signal.



ii.
A438765N02
3.031,1.375 3.406,1.625 0.375,0.25 10 false GND

Waveform 2

Item Content
Tester Connection
·

Between R5-11 (CA1N) and R5-10 (GND)

·

Between R5-12 (CANL) and R5-10 (GND)


Tool Setting 1 V/DIV., 10 μs./DIV.
Condition Ignition switch ON

HINT:

The waveform varies depending on the CAN communication signal.