15370
1.INSPECT CAM TIMING OIL CONTROL SOLENOID ASSEMBLY
Put the engine in Inspection Mode (Maintenance Mode).
| Tester Display |
|---|
| Inspection Mode |
Start the engine.
According to the display on the GTS, perform the Active Test and check the engine speed while operating the cam timing oil control solenoid assembly.
| Tester Display |
|---|
| Control the Exhaust VVT OCV Duty Ratio Bank 1 |
| GTS Operation | Engine Condition |
|---|---|
| 0% | Normal engine speed |
| 100% | Engine idles roughly or stalls |
Refer to "Data List / Active Test" [Exhaust VVT Hold Learn Value Bank 1, Exhaust VVT Change Angle Bank 1, Exhaust VVT OCV Control Duty Ratio Bank 1 and Exhaust VVT Target Angle Bank 1].
Click hereEngine / Hybrid System>A25A-FXS, A25B-FXS (ENGINE CONTROL)>SFI SYSTEM>DATA LIST / ACTIVE TEST
Test not possible with the shift lever in P during charge control. Move the shift lever to N to perform test.
If the DTCs are stored after the Active Test, clear the DTCs.
If the result is not as specified, check the cam timing oil control solenoid assembly, wire harness and ECM.