Home › Engine / Hybrid System › A25A-FXS, A25B-FXS (ENGINE CONTROL) › AIR FUEL RATIO SENSOR (for Sensor 2)
RM37A0E _51 Engine / Hybrid System _086905 A25A-FXS, A25B-FXS ENGINE CONTROL _0418429 AIR FUEL RATIO SENSOR(for Sensor 2) A

A25A-FXS, A25B-FXS ENGINE CONTROL  AIR FUEL RATIO SENSOR(for Sensor 2)  INSTALLATION  


PROCEDURE

Hide 89467C 1.INSTALL AIR FUEL RATIO SENSOR

HINT:

Perform "Inspection After Repair" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>A25A-FXS, A25B-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.
A454957C01
1.969,1.583 1.969,1.104 true 0.771,1.688 0.969,1.885 0.198,0.198 10 true *a 1.854,1.604 2.198,1.781 0.344,0.177 10 true SST
*a Torque Wrench Fulcrum Length


Using SST, install the air fuel ratio sensor to the front exhaust pipe assembly (TWC: Rear Catalyst).

SST
09224-00012  

Torque:
Specified tightening torque : 44 N*m (449 kgf*cm, 32 ft.*lbf)

NOTICE:

If the air fuel ratio sensor has been struck or dropped, replace it.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)):

37.7 N*m (384 kgf*cm, 28 ft.*lbf)




b.
A454955C01
2.719,0.74 2.719,0.281 2.719,0.281 2.906,0.281 true 2.604,0.813 2.677,1.156 2.677,1.156 2.781,0.917 true 2.938,0.177 3.146,0.354 0.208,0.177 10 true *a 2.604,1.177 2.813,1.354 0.208,0.177 10 true *b
*a Tube
*b Wire Harness Clamp


Connect the air fuel ratio sensor connector.


c.

Engage the 2 wire harness clamps so that the tube is positioned as shown in the illustration.


Hide 3.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>A25A-FXS, A25B-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION