The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during knock control sensor removal/installation are shown below.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
1.REMOVE FUEL DELIVERY PIPE
89615
2.REMOVE KNOCK CONTROL SENSOR
| *A | for Bank 1 |
| *B | for Bank 2 |
Disconnect the 2 knock control sensor connectors.
Remove the 2 bolts and 2 knock control sensors from the cylinder block sub-assembly.
If a knock control sensor has been struck or dropped, replace it.