Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR SYSTEM
RM37A0E _59 Vehicle Exterior _086885 DOOR / HATCH _0418593 POWER BACK DOOR SYSTEM D

DOOR / HATCH  POWER BACK DOOR SYSTEM  FREEZE FRAME DATA  


FREEZE FRAME DATA


a.

Whenever a DTC is detected, the multiplex network door ECU stores the current vehicle state as Freeze Frame Data.



CHECK FREEZE FRAME DATA


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Back Door / Trouble Codes.

Body Electrical > Back Door
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Half Latch SW Half-latch switch signal OFF or ON OFF: Back door lock motor in full latch or half latch position
ON: Back door lock motor in open latch position
-
Closer Position SW Position switch signal OFF or ON OFF: Back door lock center gear out of center position (Position switch off)
ON: Back door lock center gear in center position (Position switch on)
-
Pawl Position Switch Pawl position switch signal OFF or ON OFF: Back door lock motor except open latched
ON: Back door lock motor open latched
-
Courtesy SW Back door courtesy switch signal OFF or ON OFF: Back door closed
ON: Back door open
-
Back Door Position Status of the back door position -4000 to 21500 Edge 3000 to 6000 Edge -
Back Door Horizontal Torsion Status of the torsion between back door LH and RH -128 to 127 Edge -128 to 127 Edge -
Battery Voltage Status of the auxiliary battery voltage 0 to 31 V 11 to 14 V -
Closer Control Status Status of the closer control Initialize, Close 1: Standby, Close 2: Operate Standby, Close 3: Operation, Close 4: Return Standby, Close 5: Return, Release 1: Standby, Release 2: Operation, Release 3: Return Standby, Release 4: Return, Forcible 1: Release Operation, Forcible 2: Close Standby, Forcible 3: Close Operation Standby, Forcible 4: Close Operation, Forcible 5: Closer Torque Moderate, Forcible 6: Door Check or Stop Function Status of the closer control -
PBD Control Status Status of the power back door system control All Close Initialize, All Close, Open 1: Auto Open Standby, Open 2: Latch Release Standby, Open 3: Auto Open Operation, All Open, Close 1: Auto Close Standby, Close 2: Auto Close Operation, Close 3: Closer Start Standby, Close 4: All Close Standby, Neutral, Auto Close Reverse or Brake Status of the power back door system control -
#Codes Number of DTCs Min.: 0, Max.: 255 Number of DTCs will be displayed -


CLEAR FREEZE FRAME DATA


NOTICE:

Clearing the DTCs will also clear the Freeze Frame Data.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Clear the DTCs and Freeze Frame Data.