84966A
1.INSPECT NO. 1 POWER BACK DOOR CONTROL SWITCH
| *a | Component without harness connected
(No. 1 Power Back Door Control Switch) |
Check the switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 5 - 2 | Pressed (On) | Below 1 Ω |
| 5 - 2 | Not pressed (Off) | 10 kΩ or higher |
If the result is not as specified, replace the No. 1 power back door control switch.
Check the switch illumination.
Apply auxiliary battery voltage to the switch connector and check that the No. 1 power back door control switch illuminates.
| Auxiliary Battery Connection | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → Terminal 6
Auxiliary battery negative (-) → Terminal 1 |
Illumination illuminates |
If the result is not as specified, replace the No. 1 power back door control switch.