Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for 8 Inch Display)
RM37A0E _56 Audio / Visual / Telematics _086878 NAVIGATION / MULTI INFO DISPLAY _0418790 NAVIGATION SYSTEM(for 8 Inch Display) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for 8 Inch Display)  Reverse Signal Circuit  


DESCRIPTION

for HV Model

The radio and display receiver assembly receives a reverse signal from the BKUP LP relay.


for Gasoline Model

The radio and display receiver assembly receives a reverse signal from the park/neutral position switch assembly.


WIRING DIAGRAM

E429896E03
5.208,1.99 5.667,2.188 0.458,0.198 10 false H1 5.208,2.146 6.396,2.646 1.188,0.5 10 false Radio and Display Receiver Assembly 5.396,1.104 5.854,1.302 0.458,0.198 10 false REV 5.177,0.99 5.635,1.188 0.458,0.198 10 false 28 0.927,1.51 2.604,1.958 1.677,0.448 10 false from Park/Neutral Position Switch Assembly*2 1.115,1.094 2.792,1.542 1.677,0.448 10 false from BKUP LP Relay*1 2.979,2.396 4.635,2.677 1.656,0.281 10 false *2: for Gasoline Model 2.979,2.135 4.635,2.417 1.656,0.281 10 false *1: for HV Model

PROCEDURE

1.CHECK BACK-UP LIGHT
a.

Move the shift lever to R and check if the back-up lights come on.

OK:

The back-up lights come on.



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)

NG

2.CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)
a.

Disconnect the H1 radio and display receiver assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
H1-28 (REV) - Body ground Ignition switch ON
Shift lever in R
11 to 14 V
H1-28 (REV) - Body ground Ignition switch ON
Shift lever not in R
Below 1 V



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR