Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for 8 Inch Display)
RM37A0E _56 Audio / Visual / Telematics _086878 NAVIGATION / MULTI INFO DISPLAY _0418790 NAVIGATION SYSTEM(for 8 Inch Display) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for 8 Inch Display)  Start Up Signal Circuit between Radio Receiver Assembly and Navigation ECU  


DESCRIPTION

This circuit includes the navigation ECU and radio and display receiver assembly.

WIRING DIAGRAM

E367997E67
1.385,0.906 1.99,1.177 0.604,0.271 10 false SUP 1.76,0.781 2.365,1.052 0.604,0.271 10 false 21 5.375,0.781 5.979,1.052 0.604,0.271 10 false 7 0.771,1.802 1.375,2.073 0.604,0.271 10 false H18 0.771,1.969 1.833,2.26 1.063,0.292 10 false Navigation ECU 5.5,1.802 6.104,2.073 0.604,0.271 10 false H3 5.5,1.969 6.74,2.333 1.24,0.365 10 false Radio and Display Receiver Assembly 5.573,0.885 6.177,1.156 0.604,0.271 10 false SUP

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU)
a.

Disconnect the H3 radio and display receiver assembly connector.


b.

Disconnect the H18 navigation ECU connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H3-7 (SUP) - H18-21 (SUP) Always Below 1 Ω
H3-7 (SUP) or H18-21 (SUP) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR