Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for 8 Inch Display)
RM37A0E _56 Audio / Visual / Telematics _086878 NAVIGATION / MULTI INFO DISPLAY _0418790 NAVIGATION SYSTEM(for 8 Inch Display) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for 8 Inch Display)  Voice Guidance Circuit between Radio Receiver and Stereo Component Amplifier  


DESCRIPTION

This circuit is used when the voice switch of the steering pad switch assembly is pushed.

Using this circuit, the radio and display receiver assembly sends signals to the stereo component amplifier assembly.

WIRING DIAGRAM

E268439E90
0.344,2.802 1.542,3.313 1.198,0.51 10 false Radio and Display Receiver Assembly 0.344,2.635 0.896,2.979 0.552,0.344 10 false H9 0.979,0.646 1.323,0.885 0.344,0.24 10 false RL+ 1,1.417 1.344,1.656 0.344,0.24 10 false RL- 5.927,0.646 6.271,0.885 0.344,0.24 10 false II1+ 5.667,2.646 6.313,2.979 0.646,0.333 10 false M38 1.365,0.542 1.573,0.76 0.208,0.219 10 false 3 1.365,1.323 1.573,1.542 0.208,0.219 10 false 8 5.646,0.531 5.896,0.74 0.25,0.208 10 false 15 5.646,1.313 5.896,1.51 0.25,0.198 10 false 14 5.635,2.115 5.896,2.333 0.26,0.219 10 false 18 5.927,1.438 6.271,1.677 0.344,0.24 10 false II1- 5.927,2.219 6.417,2.427 0.49,0.208 10 false SLD1 3.552,1.75 4.302,1.969 0.75,0.219 10 false * 5.667,2.813 6.875,3.229 1.208,0.417 10 false Stereo Component Amplifier Assembly 2.323,3.417 3.156,3.635 0.833,0.219 10 false *: Shielded

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
a.

Disconnect the H9 radio and display receiver assembly connector.


b.

Disconnect the M38 stereo component amplifier assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester connection Condition Specified condition
H9-3 (RL+) - M38-15 (II1+) Always Below 1 Ω
H9-8 (RL-) - M38-14 (II1-) Always Below 1 Ω
M38-18 (SLD1) - Body ground Always 10 kΩ or higher
H9-3 (RL+) or M38-15 (II1+) - Body ground Always 10 kΩ or higher
H9-8 (RL-) or M38-14 (II1-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR