This is the power source circuit to operate the radio and display receiver assembly.
Inspect the fuses for circuits related to this system before performing the following procedure.
Disconnect the H1 and H2 radio and display receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H1-1 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H1-4 (+B1) - H1-1 (GND1)*1 | Ignition switch off | 11 to 14 V |
| H1-4 (+B1) - H1-1 (GND1)*2 | Always | 11 to 14 V |
| H1-15 (ACC1) - H1-1 (GND1) | Ignition switch ACC | 11 to 14 V |
| H2-19 (IG) - H1-1 (GND1) | Ignition switch ON | 11 to 14 V |
*1: for HV Model
*2: for Gasoline Model
| Proceed to |
|---|
| OK |
| NG |
OK
NG