These DTCs are stored when there is a CAN communication malfunction between the ECM, certification ECU (smart key ECU assembly), hybrid vehicle control ECU, main body ECU (multiplex network body ECU) or combination meter assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| U0100 | Lost Communication with ECM / PCM | CAN communication error between certification ECU (smart key ECU assembly) and ECM (1-trip detection logic*) | ECM | DTC Output Confirmation Operation:
Turn the ignition switch to ON and wait at least 10 seconds. |
| U0140 | Lost Communication with Main Body ECU | CAN communication malfunction between certification ECU (smart key ECU assembly) and main body ECU (multiplex network body ECU) (1-trip detection logic*) | Main body ECU (multiplex network body ECU) | DTC Output Confirmation Operation:
Always |
| U0142 | Lost Communication with Main Body ECU | CAN communication malfunction between certification ECU (smart key ECU assembly) and main body ECU (multiplex network body ECU) (1-trip detection logic*) | Main body ECU (multiplex network body ECU) | DTC Output Confirmation Operation:
Always |
| U0155 | Lost Communication with Combination Meter | CAN communication malfunction between certification ECU (smart key ECU assembly) and combination meter assembly (1-trip detection logic*) | Combination meter assembly | DTC Output Confirmation Operation:
Turn the ignition switch to ON and wait at least 10 seconds. |
| U0293 | Lost Communication with Hybrid Vehicle Control System | CAN communication error between certification ECU (smart key ECU assembly) and hybrid vehicle control ECU (1-trip detection logic*) | Hybrid vehicle control ECU | DTC Output Confirmation Operation:
Turn the ignition switch to ON and wait at least 10 seconds. |
*: Only detected while a malfunction is present.
| DTC Code | Vehicle Condition when Malfunction Detected | Fail-safe Function when Malfunction Detected |
|---|---|---|
| U0100 | There is no effect on vehicle behavior. | - |
| U0140
U0142 |
·
Doors cannot be locked or unlocked. ·
The warning (wireless buzzer) does not sound. |
- |
| U0155 | The warning (meter buzzer) does not sound and no warning messages displayed on the multi-information display. | - |
| U0293 | The warning (meter buzzer) does not sound and no warning messages displayed on the multi-information display. | - |
| DTC No. | Data List and Active Test |
|---|---|
| U0100
U0140 U0142 U0155 U0293 |
- |
When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
When the cable is disconnected and reconnected to the negative (-) auxiliary battery terminal, the power source mode returns to the state it was in before the cable was disconnected.
Check for DTCs and note any DTCs that are output.
| Proceed to |
|---|
| NEXT |
NEXT