Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM (for Start Function, HV Model)
RM37A0E _58 Vehicle Interior _086886 THEFT DETERRENT / KEYLESS ENTRY _0419081 ENTRY AND START SYSTEM(for Start Function, HV Model) D

THEFT DETERRENT / KEYLESS ENTRY  ENTRY AND START SYSTEM(for Start Function, HV Model)  CHECK FOR INTERMITTENT PROBLEMS  


NOTICE:
·

Operation history is stored in the RAM or EEPROM of the certification ECU (smart key ECU assembly). As the cause of a malfunction stored in the RAM will be cleared when the cable is disconnected from the negative (-) auxiliary battery terminal, do not disconnect the cable from the negative (-) auxiliary battery terminal before checking and recording are complete.

·

If the vehicle or vehicle controls are operated (for example, during initial inspection when the vehicle is brought in for repair) before operation history has been read and saved, the operation history information could be lost.

·

The operation history function uses the current system time of the GTS and the time counter inside the controlling ECU to calculate the time shown in the operation history. For this reason, before reading the operation history, first make sure that the GTS system clock is accurately set to the current time.



OPERATION HISTORY


HINT:

The certification ECU (smart key ECU assembly) stores the operation history of the entry and start system and it can be read using the GTS.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Entry&Start / Utility / Operation History / (desired item).

Body Electrical > Entry&Start > Utility
Tester Display
Operation History
50005 125 1052

e.

According to the display on the GTS, read and save the operation history.

Operation History List
Auto Entry Mode Switch History
Auto Entry Wireless Operation History
Warning Operation History
Engine Start
Customize(Auto Entry Cancel)
Customize(Door Unlock Mode Switch)
Radio Wave Interference (RF Signal Received)
Engine Start (inactive)
Remote Engine Starter (inactive)
Auto Entry Unlock (inactive)
Registration Function (Reason for Non-operation)
Auto Entry Lock (inactive)
Engine Start Inactive (Brake/Clutch System)
Radio Wave Interference (RF Reception Not Available)
Engine Start Inactive (Steering Lock System)

HINT:

Some items may not be displayed depending on the specifications of the vehicle.