Home › Engine / Hybrid System › A25A-FXS, A25B-FXS (COOLING) › WATER PUMP
RM37A0E _51 Engine / Hybrid System _086910 A25A-FXS, A25B-FXS COOLING _0419152 WATER PUMP A

A25A-FXS, A25B-FXS COOLING  WATER PUMP  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 16032 1.INSTALL ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)

a.

Install a new gasket to the engine water pump assembly (water inlet housing).

HINT:

Be sure to clean the contact surfaces.



b.

Install the engine water pump assembly (water inlet housing) to the cylinder block assembly with the 4 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


c.

Connect the engine water pump assembly (water inlet housing) connector.


d.
A455388C01
2.354,0.521 2.573,0.521 2.573,0.521 2.948,1.479 false 1.958,1.531 2.823,1.531 false 2.167,0.427 2.49,0.677 0.323,0.25 10 true *a 1.76,1.438 2.042,1.646 0.281,0.208 10 true *b
*a Protrusion
*b Cutout


Align the protrusion of the engine water pump assembly (water inlet housing) with the cutout in the sensor wire clamp.


e.

Using an 8 mm socket wrench, connect the sensor wire to the engine water pump assembly (water inlet housing) with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


f.

Connect the sensor wire connector.


Hide 16031 2.INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY