Home › Engine / Hybrid System › A25A-FXS, A25B-FXS (COOLING) › WATER PUMP
RM37A0E _51 Engine / Hybrid System _086910 A25A-FXS, A25B-FXS COOLING _0419152 WATER PUMP A

A25A-FXS, A25B-FXS COOLING  WATER PUMP  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine water pump assembly (water inlet housing) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly

·

Replacement of EGR valve assembly

·

Gas leak from exhaust system is repaired


Perform Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 16031 2.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

Hide 16032 3.REMOVE ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)

a.
A455386

Disconnect the sensor wire connector.


b.
A455387

Using an 8 mm socket wrench, remove the bolt and disconnect the sensor wire from the engine water pump assembly (water inlet housing).


c.
A455389

Disconnect the engine water pump assembly (water inlet housing) connector.


d.
A455390

Remove the 4 bolts and engine water pump assembly (water inlet housing) from the cylinder block assembly.


e.
A402026

Remove the gasket from the engine water pump assembly (water inlet housing).