Operation history is stored in the RAM or EEPROM of the certification ECU (smart key ECU assembly). As the cause of a malfunction stored in the RAM will be cleared when the cable is disconnected from the negative (-) auxiliary battery terminal, do not disconnect the cable from the negative (-) auxiliary battery terminal before checking and recording are complete.
If the vehicle or vehicle controls are operated (for example, during initial inspection when the vehicle is brought in for repair) before operation history has been read and saved, the operation history information could be lost.
The operation history function uses the current system time of the GTS and the time counter inside the controlling ECU to calculate the time shown in the operation history. For this reason, before reading the operation history, first make sure that the GTS system clock is accurately set to the current time.
OPERATION HISTORY
The certification ECU (smart key ECU assembly) stores the operation history of the entry and start system and it can be read using the GTS.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Entry&Start / Utility / Operation History / (desired item).
| Tester Display |
|---|
| Operation History |
According to the display on the GTS, read and save the operation history.
| Operation History List |
|---|
| Auto Entry Mode Switch History |
| Auto Entry Wireless Operation History |
| Warning Operation History |
| Engine Start |
| Customize(Auto Entry Cancel) |
| Customize(Door Unlock Mode Switch) |
| Radio Wave Interference (RF Signal Received) |
| Engine Start (inactive) |
| Remote Engine Starter (inactive) |
| Auto Entry Unlock (inactive) |
| Registration Function (Reason for Non-operation) |
| Auto Entry Lock (inactive) |
| Engine Start Inactive (Brake/Clutch System) |
| Radio Wave Interference (RF Reception Not Available) |
| Engine Start Inactive (Steering Lock System) |
Some items may not be displayed depending on the specifications of the vehicle.
SYMPTOM SIMULATION
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING