63306
1.INSTALL SUNSHADE TRIM SUB-ASSEMBLY
|
Install in this Direction |
Insert the sunshade trim sub-assembly into the sliding roof housing sub-assembly as shown in the illustration.
|
Install in this Direction |
Install the rear sliding roof sunshade stopper as shown in the illustration.
Use the same procedure for the RH side.
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Engage the 2 claws in the direction indicated by the arrow (1) shown in the illustration.
Engage the guide in the direction indicated by the arrow (2) shown in the illustration.
Install the sliding roof piece sub-assembly LH with the screw.
Use the same procedure for the RH side.
63260H
2.INSTALL SLIDING ROOF DRIVE GEAR ASSEMBLY
Apply MP grease to the gear of the sliding roof drive gear assembly.
Install the sliding roof drive gear assembly with the 2 bolts.
|
Install in this Direction |
Engage the guide and claw as shown in the illustration.
Install the map light bracket with the bolt.