81260A
1.INSPECT MAP LIGHT ASSEMBLY (for Slidng Roof)
| *a | Component without harness connected
(Map Light Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 17 - 11 | UP switch pressed | Below 1 Ω |
| 17 - 11 | UP switch not pressed | 10 kΩ or higher |
| 18 - 11 | DOWN switch pressed | Below 1 Ω |
| 18 - 11 | DOWN switch not pressed | 10 kΩ or higher |
| 20 - 11 | OPEN switch pressed | Below 1 Ω |
| 20 - 11 | OPEN switch not pressed | 10 kΩ or higher |
| 19 - 11 | CLOSE switch pressed | Below 1 Ω |
| 19 - 11 | CLOSE switch not pressed | 10 kΩ or higher |
If the result is not as specified, replace the map light assembly.
81260A
2.INSPECT MAP LIGHT ASSEMBLY (for Panoramic Moon Roof)
| *a | Component without harness connected
(Map Light Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 20 - 11 | Sliding roof switch slid backward | Below 1 Ω |
| 20 - 11 | Sliding roof switch not slid backward | 10 kΩ or higher |
| 19 - 11 | Sliding roof switch slid forward | Below 1 Ω |
| 19 - 11 | Sliding roof switch not slid forward | 10 kΩ or higher |
| 16 - 11 | Sliding roof switch pressed | Below 1 Ω |
| 16 - 11 | Sliding roof switch not pressed | 10 kΩ or higher |
| 17 - 11 | Roof sunshade switch slid backward | Below 1 Ω |
| 17 - 11 | Roof sunshade switch not slid backward | 10 kΩ or higher |
| 18 - 11 | Roof sunshade switch slid forward | Below 1 Ω |
| 18 - 11 | Roof sunshade switch not slid forward | 10 kΩ or higher |
If the result is not as specified, replace the map light assembly.