This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
51420
1.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
Remove the 4 bolts, 2 screws, 6 clips and No. 2 engine under cover assembly.
2.DRAIN ENGINE OIL
12102A
3.REMOVE NO. 2 OIL PAN SUB-ASSEMBLY
89491
4.REMOVE ENGINE OIL LEVEL SENSOR
Disconnect the engine oil level sensor connector.
Remove the clip from the engine oil level sensor.
Using an 8 mm socket wrench, remove the 2 bolts and engine oil level sensor from engine balancer assembly.