Home › General › MAINTENANCE › A25A-FXS, A25B-FXS AUXILIARY BATTERY
RM37A0E _V1 General _086848 MAINTENANCE _0419975 A25A-FXS, A25B-FXS AUXILIARY BATTERY A

MAINTENANCE  A25A-FXS, A25B-FXS AUXILIARY BATTERY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during auxiliary battery removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)

NOTICE:
·

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.

·

When replacing the auxiliary battery, use a new auxiliary battery of the same dimensions and same capacity or more from the same class at a 20-hour rate.

·

After replacing the auxiliary battery, install the ventilation hole plug supplied with the new auxiliary battery or the ventilation hole plug from the old auxiliary battery to the ventilation hole on the side to which the battery hose is not connected.



PROCEDURE

Hide 58441L 1.REMOVE BATTERY SERVICE HOLE COVER

a.
A456720

Turn back the deck board assembly as shown in the illustration.


b.
B561858

Disengage the 6 claws and 2 guides to remove the battery service hole cover.


Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

a.
A454860

Loosen the nut, and disconnect the cable from the negative (-) auxiliary battery terminal.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



Hide 3.REMOVE AUXILIARY BATTERY

a.

Open the battery terminal connector cover.


b.
A454861

Loosen the nut and disconnect the cable from the positive (+) auxiliary battery terminal.


c.
A454862

Disconnect the battery hose from the auxiliary battery.


d.
A454863

Remove the bolt, nut and battery clamp sub-assembly.


e.
A454864C01
2.406,1.99 2.229,1.99 2.229,1.99 2.125,1.656 true 2.458,1.885 2.708,2.104 0.25,0.219 10 true *a
*a Slope
V113147

Lift and pull in this direction


Lift the auxiliary battery along the slope to remove it as shown in the illustration.


f.

w/ Battery Insulator:

i.

Remove the battery insulator from the auxiliary battery.