The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during generator assembly removal/installation are shown below.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
16400
2.REMOVE RADIATOR ASSEMBLY
16361A
3.REMOVE V-RIBBED BELT
27020
4.REMOVE GENERATOR ASSEMBLY
Open the terminal cap.
Remove the nut and disconnect the wire harness from terminal B.
Disconnect the generator assembly connector.
Disconnect the compressor assembly with magnetic clutch connector.
Disengage the wire harness clamp.
Type A:
Remove the bolt.
Type B:
Remove the nut.
Remove the 2 bolts and generator assembly.
Remove the bolt and wire harness clamp bracket from the generator assembly.
Remove the bolt and No. 1 generator bracket from the generator assembly.