The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during battery removal/installation are shown below.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
When replacing the battery, use a new battery of the same dimensions and same capacity or more from the same class at a 20-hour rate.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2.REMOVE BATTERY