Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID VEHICLE CONTROL ECU › 2020.02–2020.11
RM37A0E _51 Engine / Hybrid System _086850 HYBRID / BATTERY CONTROL _0419996 HYBRID VEHICLE CONTROL ECU A

HYBRID / BATTERY CONTROL  HYBRID VEHICLE CONTROL ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during hybrid vehicle control ECU removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Learning can also be performed using the GTS.

Click here(Click here)

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane control system (Click here)
Parking Support Brake System*1
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)
Replacement of hybrid vehicle control ECU Code registration
·

Wireless Door Lock Control System

·

Entry and Start System (for Entry function)

·

Entry and Start System (for start function, HV model)

·

Hybrid control system cannot be started


See Service Bulletin for the registration method

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 73900 1.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 55308B 2.REMOVE NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY

Hide 82878 3.REMOVE ECU INTEGRATION BOX LH

a.

Disconnect each connector.


b.
A451904

Disconnect the 3 hybrid vehicle control ECU connectors as shown in the illustration.


c.
A451905

Remove the nut, 2 bolts and ECU integration box LH.


Hide 89981 4.REMOVE HYBRID VEHICLE CONTROL ECU

a.
A451906

Disengage the 2 claws and remove the hybrid vehicle control ECU from the ECU integration box LH.

NOTICE:
·

If the ECU integration box LH is deformed or damaged, replace it.

·

Do not bend the 2 claws more than necessary.