Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › WATER PUMP WITH MOTOR
RM37A0E _51 Engine / Hybrid System _086850 HYBRID / BATTERY CONTROL _0420001 WATER PUMP WITH MOTOR A

HYBRID / BATTERY CONTROL  WATER PUMP WITH MOTOR  REMOVAL  


PROCEDURE

Hide 1.DRAIN COOLANT (for Inverter)

Hide G9040 2.REMOVE INVERTER WATER PUMP ASSEMBLY

a.
A455499C01
1.125,1.521 1.458,1.521 1.458,1.521 1.542,1.354 true 1.667,0.646 1.917,0.646 1.917,0.646 2.073,0.865 true 1.479,0.552 1.646,0.74 0.167,0.188 10 true *1 0.927,1.427 1.094,1.625 0.167,0.198 10 true *2
*1 No. 2 Inverter Cooling Hose
*2 No. 3 Inverter Cooling Hose


Slide the 2 clips and disconnect the No. 2 inverter cooling hose and No. 3 inverter cooling hose.

NOTICE:
·

Put pieces of cloth into the pipes and disconnected hoses or cover the pipes and hoses with plastic bags to prevent foreign matter from entering the inverter water pump with motor assembly and inverter cooling system.

·

Do not apply excessive force to the hoses.




b.
A455500

Disconnect the inverter water pump assembly connector.

NOTICE:
To prevent coolant from entering the inverter water pump assembly connector, perform the following procedure.
·

Wipe off any coolant around the inverter water pump assembly connector before disconnecting it.

·

Apply insulating tape to the connectors of the wire harness and inverter water pump assembly to prevent the entry of coolant.




c.

Remove the 2 bolts and inverter water pump assembly from the HV water pump bracket sub-assembly.

NOTICE:

If the inverter water pump assembly has been struck or dropped, replace it.



Hide G9031A 3.REMOVE HV WATER PUMP BRACKET SUB-ASSEMBLY

HINT:

Perform this procedure only when replacement of the HV water pump bracket sub-assembly is necessary.


a.
A455501

Remove the 2 bolts and HV water pump bracket sub-assembly.