Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR SEAT ENTERTAINMENT SYSTEM
RM37A0E _56 Audio / Visual / Telematics _086877 AUDIO / VIDEO _0420185 REAR SEAT ENTERTAINMENT SYSTEM J

AUDIO / VIDEO  REAR SEAT ENTERTAINMENT SYSTEM  Illumination Circuit  


DESCRIPTION

Power is supplied to the television display assembly when the light control switch is in the tail or head position.

WIRING DIAGRAM

E436454E01
2.635,1.01 5.083,1.208 2.448,0.198 10 false to Other Systems 2.229,1.573 3.573,1.854 1.344,0.281 10 false from TAIL Relay 3.958,1.76 4.594,2.042 0.635,0.281 10 false PANEL 5.417,1.583 6.052,1.865 0.635,0.281 10 false ILL+ 5.125,1.469 5.427,1.688 0.302,0.219 10 false 15 5.104,2.698 5.406,2.917 0.302,0.219 10 false 16 5.396,2.833 6.031,3.115 0.635,0.281 10 false ILL- 5.354,3.458 5.99,3.74 0.635,0.281 10 false R16 5.344,3.635 6.646,3.979 1.302,0.344 10 false Television Display Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuse for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK METER / GAUGE SYSTEM
a.

Check if the rheostat function operates normally.

OK:

The rheostat function operates normally.



Result:
Proceed to
OK
NG



OK

2.CHECK LIGHTING SYSTEM (INT)

NG

2.CHECK LIGHTING SYSTEM (INT)
a.

Check if the instrument panel illumination comes on normally.

OK:

The instrument panel illumination comes on normally.



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL CIRCUIT)

NG

3.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL CIRCUIT)
a.

Disconnect the R16 television display assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
R16-15 (ILL+) - Body ground Ignition switch off
Light control switch in tail or head position
11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
R16-16 (ILL-) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR