Home › Drivetrain › GF2A (TRANSFER / 4WD / AWD) › TRANSFER OIL
RM37A0E _52 Drivetrain _086861 GF2A TRANSFER / 4WD / AWD _0420302 TRANSFER OIL G

GF2A TRANSFER / 4WD / AWD  TRANSFER OIL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK TRANSFER OIL

a.

Stop the vehicle on a level surface.


b.
C426185

Using a 10 mm straight hexagon wrench and 10 x 12 mm long offset wrench, remove the transfer filler plug and gasket from the transfer assembly.


c.
C278961C01
2.667,0.854 2.979,1.052 0.313,0.198 10 false *a
*a 0 to 5 mm (0 to 0.197 in.)


Check that the oil level is between 0 to 5 mm (0 to 0.197 in.) from the bottom lip of the transfer filler plug hole.

If the result is not as specified, add transfer oil.

Oil Type:

Toyota genuine differential gear oil LX


NOTICE:
·

Using transfer oil other than the specified oil may cause abnormal noise or vibration, or damage the transfer of the vehicle.

·

When adding transfer oil, pour it slowly.

·

Too much or too little transfer oil will lead to transfer problems.




d.

If the oil level is low, refill transfer oil after checking for oil leaks.


e.
C426187C01
0.5,4.417 0.396,4.417 0.396,4.417 0.396,4.167 false 0.417,3.99 0.417,3.448 0.417,3.448 0.531,3.448 false 1.063,3.958 1.063,3.177 1.063,3.177 1.177,3.177 false 0.542,4.323 0.854,4.479 0.313,0.156 10 false *a 0.573,3.365 0.885,3.521 0.313,0.156 10 false *b 2.083,3.354 2.396,3.51 0.313,0.156 10 false *c 1.271,3.094 1.583,3.26 0.313,0.167 10 false SST
*a 10 mm Straight Hexagon Wrench
*b 10 mm Union Nut Wrench
*c Torque Wrench Fulcrum Length


Using SST, a 10 mm straight hexagon wrench and 10 mm union nut wrench, install the transfer filler plug and a new gasket to the transfer assembly.

SST
09961-00950  

Torque:
Specified tightening torque : 39 N*m (398 kgf*cm, 29 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a 10 mm union nut wrench (fulcrum length of 22 mm (0.866 in.)) + SST (fulcrum length of 150 mm (5.91 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 19.9 N*m (203 kgf*cm, 15 ft.*lbf)




Hide 2.INSPECT FOR TRANSFER OIL LEAK