Home › General › SPECIFICATIONS › GF2A TRANSFER / 4WD / AWD
RM37A0E _V1 General _086915 SPECIFICATIONS _0415889 GF2A TRANSFER / 4WD / AWD F

SPECIFICATIONS  GF2A TRANSFER / 4WD / AWD  SERVICE DATA  


Transfer Oil

*: Using transfer oil other than the specified oil may cause abnormal noise or vibration, or damage the transfer of the vehicle.

Oil Type Standard Capacity (for Reference)
Toyota genuine differential gear oil LX* 0.39 liters (0.41 US qts, 0.34 Imp. qts)

Transfer Case Front Oil Seal (for LH Side)
Transfer case oil seal Standard Depth 9.5 to 10.5 mm (0.374 to 0.413 in.)

Transfer Case Front Oil Seal (for RH Side)
Transfer case oil seal RH Standard Depth -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

Transfer Case Rear Oil Seal
Transfer case oil seal Standard Depth 3.9 to 4.9 mm (0.154 to 0.193 in.)

Transfer Assembly
Transfer case oil seal RH Standard Depth -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
Transfer case straight pin Protrusion Height 10.8 to 11.8 mm (0.425 to 0.465 in.)

Multi-terrain Select Switch
Multi-terrain select switch (No. 1 pattern select switch assembly) (for Dial Switch Type)
Tester Connection Condition Specified Condition
6 (B) - 3 (E) NORMAL mode switch being pushed and held 80.4 to 83.6 Ω
NORMAL mode switch not pushed 10 kΩ or higher
6 (B) - 3 (E) ROCK & DIRT mode switch being turned and held 580.2 to 603.8 Ω
ROCK & DIRT mode switch not turned 10 kΩ or higher
6 (B) - 3 (E) MUD & SAND mode switch being turned and held 2.050 to 2.134 kΩ
MUD & SAND mode switch not turned 10 kΩ or higher
Measurement Condition Specified Condition
Battery positive (+) → 7 (ILL+) Illuminates
Battery negative (-) → 2 (ILL-)
Crawl control switch assembly (for Push Switch Type)
Tester Connection Condition Specified Condition
6 (B) - 3 (E) NORMAL mode switch being pushed and held 80.4 to 83.6 Ω
NORMAL mode switch not pushed 10 kΩ or higher
6 (B) - 3 (E) ROCK & DIRT mode switch being pushed and held 580.2 to 603.8 Ω
ROCK & DIRT mode switch not pushed 10 kΩ or higher
6 (B) - 3 (E) MUD & SAND mode switch being pushed and held 2.050 to 2.134 kΩ
MUD & SAND mode switch not pushed 10 kΩ or higher
Measurement Condition Specified Condition
Battery positive (+) → 7 (ILL+) Illuminates
Battery negative (-) → 2 (ILL-)