CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Reconnect the instrument panel junction block assembly connectors.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| MB-11 (GND1) - Body ground | Ground | Always | Below 1 Ω |
| MB-30 (ACC) - Body ground | ACC power supply | Ignition switch ACC | 11 to 14 V |
| Ignition switch off | Below 1 V | ||
| MB-31 (BECU) - Body ground | Auxiliary battery power supply | Ignition switch off*1
Always*2 |
11 to 14 V |
| MB-32 (IG) - Body ground | IG power supply | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | ||
| MB-2 (RCTY) - Body ground*3 | Rear door courtesy light switch RH input | Rear door RH closed (OFF) | 10 kΩ or higher |
| Rear door RH open (ON) | Below 1 Ω | ||
| MB-13 (LCTY) - Body ground*3 | Rear door courtesy light switch LH input | Rear door LH closed (OFF) | 10 kΩ or higher |
| Rear door LH open (ON) | Below 1 Ω | ||
| MB-18 (DBKL) - Body ground | Driver seat belt buckle switch signal | Driver seat belt fastened | 10 kΩ or higher |
| Driver seat belt unfastened | Below 1 Ω | ||
| H42-19 (GND2) - Body ground | Ground | Always | Below 1 Ω |
*1: for HV Model
*2: for Gasoline Model
*3: w/ Rear Seat Belt Warning
CHECK COMBINATION METER ASSEMBLY
Disconnect the H21 combination meter assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| H21-40 (B) - Body ground | Auxiliary battery power supply | Ignition switch off*1
Always*2 |
11 to 14 V |
| H21-39 (IG+) - Body ground | Ignition power supply | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V | ||
| H21-21 (ES) - Body ground | Ground | Always | Below 1 Ω |
| H21-10 (PBKL) - Body ground | Front passenger seat belt buckle switch signal | Front passenger seat belt fastened | 10 kΩ or higher |
| Front passenger seat belt unfastened | Below 1 Ω | ||
| H21-11 (PODS) - Body ground | Occupant detection sensor signal | Front passenger seat occupied | Below 100 Ω |
| Front passenger seat not occupied | 1 MΩ or higher | ||
| H21-24 (RLSB) - Body ground*3 | Rear No. 1 seat belt LH buckle switch signal | Rear No. 1 seat belt LH fastened | 10 kΩ or higher |
| Rear No. 1 seat belt LH unfastened | Below 1 Ω | ||
| H21-25 (RCSB) - Body ground*3 | Rear No. 1 seat belt center buckle switch signal | Rear No. 1 seat belt center fastened | 10 kΩ or higher |
| Rear No. 1 seat belt center unfastened | Below 1 Ω | ||
| H21-26 (RRSB) - Body ground*3 | Rear No. 1 seat belt RH buckle switch signal | Rear No. 1 seat belt RH fastened | 10 kΩ or higher |
| Rear No. 1 seat belt RH unfastened | Below 1 Ω | ||
| H21-13 (RLBT) - Body ground*3 | Rear No. 2 seat belt LH buckle switch signal | Rear No. 2 seat belt LH fastened | 10 kΩ or higher |
| Rear No. 2 seat belt LH unfastened | Below 1 Ω | ||
| H21-3 (RRBT) - Body ground*3 | Rear No. 2 seat belt RH buckle switch signal | Rear No. 2 seat belt RH fastened | 10 kΩ or higher |
| Rear No. 2 seat belt RH unfastened | Below 1 Ω |
*1: for HV Model
*2: for Gasoline Model
*3: w/ Rear Seat Belt Warning