If there is a short in a speaker circuit, the radio and display receiver assembly detects it and stops output to the speakers.
Thus sound cannot be heard from the speakers even if there is no malfunction in the radio and display receiver assembly or speakers.
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>PRECAUTION
Enter the "System Check Mode" screen. Refer to Check Speaker in Operation Check.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>OPERATION CHECK
Perform the operation check above and determine the speaker that is not operating.
If sound cannot be heard from any speaker, inspect all of them.
| Not Operating Speaker | Proceed to |
|---|---|
| Front No. 1 speaker assembly or front No. 2 speaker assembly | A |
| Rear speaker assembly | B |
A
B
Disconnect the H9 radio and display receiver assembly connector.
Disconnect the J1 and J17 front No. 1 speaker assembly connectors.
Disconnect the H71 and H73 front No. 2 speaker assembly connectors.
Measure the resistance according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H9-1 (FR+) - H71-4 (TWR+) | Always | Below 1 Ω |
| H9-6 (FR-) - H71-2 (TWR-) | Always | Below 1 Ω |
| H9-2 (FL+) - H73-4 (TWL+) | Always | Below 1 Ω |
| H9-7 (FL-) - H73-2 (TWL-) | Always | Below 1 Ω |
| J1-2 - H71-3 (+) | Always | Below 1 Ω |
| J1-1 - H71-1 (-) | Always | Below 1 Ω |
| J17-2 - H73-3 (+) | Always | Below 1 Ω |
| J17-1 - H73-1 (-) | Always | Below 1 Ω |
| H9-1 (FR+) or H71-4 (TWR+) - Body ground | Always | 10 kΩ or higher |
| H9-6 (FR-) or H71-2 (TWR-) - Body ground | Always | 10 kΩ or higher |
| H9-2 (FL+) or H73-4 (TWL+) - Body ground | Always | 10 kΩ or higher |
| H9-7 (FL-) or H73-2 (TWL-) - Body ground | Always | 10 kΩ or higher |
| J1-2 or H71-3 (+) - Body ground | Always | 10 kΩ or higher |
| J1-1 or H71-1 (-) - Body ground | Always | 10 kΩ or higher |
| J17-2 or H73-3 (+) - Body ground | Always | 10 kΩ or higher |
| J17-1 or H73-1 (-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL
Inspect the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 2 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>REMOVAL
Inspect the front No. 2 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>INSPECTION
Malfunction disappears.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the H9 radio and display receiver assembly connector.
Disconnect the K1 and K6 rear speaker assembly connectors.
Measure the resistance according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H9-4 (RR+) - K1-2 | Always | Below 1 Ω |
| H9-9 (RR-) - K1-1 | Always | Below 1 Ω |
| H9-3 (RL+) - K6-2 | Always | Below 1 Ω |
| H9-8 (RL-) - K6-1 | Always | Below 1 Ω |
| H9-4 (RR+) or K1-2 - Body ground | Always | 10 kΩ or higher |
| H9-9 (RR-) or K1-1 - Body ground | Always | 10 kΩ or higher |
| H9-3 (RL+) or K6-2 - Body ground | Always | 10 kΩ or higher |
| H9-8 (RL-) or K6-1 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>REMOVAL
Inspect the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG