The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear brake flexible hose removal/installation are shown below.
If both left and right rear flexible hoses are disconnected at the same time, be sure to place an identification mark on each hose to indicate its installation position.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal. (for HV Model)
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.DISABLE BRAKE CONTROL (for HV Model)
Click hereBrake>BRAKE (REAR)>REAR BRAKE>REMOVAL
2.REMOVE REAR WHEEL
3.DRAIN BRAKE FLUID
If brake fluid leaks onto any painted surface, immediately wash it off.
47319F
4.REMOVE REAR FLEXIBLE HOSE
Remove the union bolt and gasket, and disconnect the rear flexible hose from the rear disc brake cylinder assembly.
Remove the 2 bolts and separate the rear flexible hose.
Using a union nut wrench, disconnect the brake line while holding the rear flexible hose with a wrench.
Do not kink or damage the brake line.
Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting parts.
Remove the clip and rear flexible hose from the vehicle body.