The No. 2 air conditioning control assembly communicates with the air conditioning amplifier assembly via LIN communication.
If a malfunction occurs in the LIN communication system, the air conditioning amplifier assembly will not operate even if the No. 2 air conditioning control assembly is operated.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory |
|---|---|---|---|---|
| B14B3 | Lost Communication with Rear Panel LIN | Lost communication with No. 2 air conditioning control assembly | ·
Harness or connector ·
No. 2 air conditioning control assembly ·
Air conditioning amplifier assembly |
Memorized
(10 sec. or more)* |
*: The air conditioning amplifier assembly stores this DTC if the malfunction has occurred for the period of time indicated in the brackets.
Inspect the fuses for circuits related to this system before performing the following procedure.
| *a | Front view of wire harness connector
(to No. 2 Air Conditioning Control Assembly) |
Disconnect the T2 No. 2 air conditioning control assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| T2-7 (E) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| T2-9 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the H64 air conditioning amplifier assembly connector.
Disconnect the T2 No. 2 air conditioning control assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H64-20 (RLIN) - T2-8 (RLIN) | Always | Below 1 Ω |
| H64-20 (RLIN) or T2-8 (RLIN) - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Connect the H64 air conditioning amplifier assembly connector.
Disconnect the T2 No. 2 air conditioning control assembly connector.
Using an oscilloscope, check the waveform.
| *a | Component with harness connected
(Air Conditioning Amplifier Assembly) |
- | - |
| Item | Content |
|---|---|
| Tester Connection | H64-20 (RLIN) - Body ground |
| Tool Setting | 2 V/DIV., 20 μs/DIV. |
| Condition | Ignition switch ON |
The waveform displays properly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG