If none of the switch indicators on the air conditioning control assembly illuminate, the following factors may be the cause.
| Malfunction Status | Factor |
|---|---|
| A/C switch indicator does not illuminate | ·
Air conditioning amplifier assembly malfunction ·
Air conditioning control assembly malfunction ·
A/C switch malfunction ·
A/C switch indicator malfunction (including when indicator turned off without switch operation) ·
Servo motor initialization (incomplete) ·
Mechanical locking of damper and damper link ·
Refrigerant pressure is extremely low ·
Low detected ambient temperature (including thermistor assembly malfunction) |
Check the malfunction status of switch indicators on the air conditioning control assembly.
| Result | Proceed to |
|---|---|
| A/C switch indicators are not always illuminated | A |
| A/C switch indicators are not illuminated only immediately after starting the hybrid control system | B |
A
B
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for HV Model)>INITIALIZATION
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Ambient Temp Sensor | Ambient temp. sensor (thermistor assembly) | Min.: -23.30°C (-9.94°F)
Max.: 65.95°C (150.71°F) |
Actual ambient temperature displayed | Ambient temp. sensor (thermistor assembly) circuit malfunction
·
When open circuit: -23.30°C (-9.94°F) ·
When short circuit: 65.95°C (150.71°F) |
| Tester Display |
|---|
| Ambient Temp Sensor |
The display is as specified in the normal condition column (0°C (32°F) or higher).
| Proceed to |
|---|
| OK |
| NG |
OK
NG