RM37A0E
_V1
General
_086915
SPECIFICATIONS
_0415870
P810 HYBRID TRANSMISSION / TRANSAXLE
F
SPECIFICATIONS P810 HYBRID TRANSMISSION / TRANSAXLE SERVICE DATA
Hybrid Transaxle System
| Maintenance mode engine idle speed
|
Hybrid transaxle fluid temperature
|
Hybrid transaxle fluid pressure
|
| 900 to 1000 rpm
|
20 to 50°C (68 to 122°F)
|
9.8 kPa (0.1 kgf/cm2, 1.4 psi) or more
|
Hybrid Transaxle Fluid
|
|
| Hybrid transaxle fluid standard capacity (for Reference)
|
Classification
|
| 4.4 liters (4.6 US qts, 3.9 Imp. qts)
|
Toyota Genuine ATF WS*
|
Hybrid Transaxle Oil Seal
| Front drive shaft oil seal RH
|
Standard depth
|
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
|
| Front drive shaft oil seal LH
|
Standard depth
|
-0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
|
Input Shaft Oil Seal
| Input shaft type T oil seal
|
Standard depth
|
1.9 to 2.7 mm (0.0748 to 0.106 in.)
|
Shift Lever
| Shift lock control ECU
|
| Inspect wire harness:
|
| Tester Connection
|
Condition
|
Specified Condition
|
| 5 (IG) - Body ground
|
Ignition switch ON (IG)
|
11 to 14 V
|
| Ignition switch off
|
Below 1 V
|
| 4 (STP) - Body ground
|
Ignition switch ON (IG), brake pedal depressed
|
11 to 14 V
|
| Ignition switch ON (IG), brake pedal released
|
Below 1 V
|
| 1 (E) - Body ground
|
Always
|
Below 1 Ω
|
| Inspect shift lock solenoid:
|
| Tester Connection
|
Condition
|
Specified Condition
|
| 4 (P) - 3 (E2)
|
Shift lever in P
|
10 kΩ or higher
|
| Shift lever not in P
|
Below 1 Ω
|
| 1 (SLS+) - 2 (SLS-)
|
Always
|
112 Ω
|
| Transmission Control Switch
|
| Tester Connection
|
Condition
|
Specified Condition
|
| 4 (IG) - 5 (S)
|
Shift lever in S, "+" or "-"
|
Below 1 Ω
|
| Shift lever not in S, "+" or "-"
|
10 kΩ or higher
|
| 3 (SFTU) - 2 (E)
|
Shift lever held in "+"
(Up-shift)
|
Below 1 Ω
|
Shift lever not held in "+"
(Up-shift)
|
10 kΩ or higher
|
| 1 (SFTD) - 2 (E)
|
Shift lever held in "-"
(Down-shift)
|
Below 1 Ω
|
Shift lever not held in "-"
(Down-shift)
|
10 kΩ or higher
|
Shift Lever Position Sensor
| Tester Connection
|
Condition
|
Specified Condition
|
| 7 (+B) - 3 (PR)
|
Shift lever in P
|
Below 1 Ω
|
| 7 (+B) - 4 (PNB)
|
Below 1 Ω
|
| 7 (+B) - 8 (P)
|
Below 1 Ω
|
| 7 (+B) - 1 (DB1), 2 (N), 6 (DB2) or 9 (R)
|
Shift lever in P
|
10 kΩ or higher
|
| 7 (+B) - 3 (PR)
|
Shift lever in R
|
Below 1 Ω
|
| 7 (+B) - 9 (R)
|
Below 1 Ω
|
| 7 (+B) - 1 (DB1), 2 (N), 4 (PNB), 6 (DB2) or 8 (P)
|
Shift lever in R
|
10 kΩ or higher
|
| 7 (+B) - 2 (N)
|
Shift lever in N
|
Below 1 Ω
|
| 7 (+B) - 4 (PNB)
|
Below 1 Ω
|
| 7 (+B) - 1 (DB1), 3 (PR), 6 (DB2), 8 (P) or 9 (R)
|
Shift lever in N
|
10 kΩ or higher
|
| 7 (+B) - 1 (DB1)
|
Shift lever in D or S
|
Below 1 Ω
|
| 7 (+B) - 6 (DB2)
|
Below 1 Ω
|
| 7 (+B) - 2 (N), 3 (PR), 4 (PNB), 8 (P) or 9 (R)
|
Shift lever in D or S
|
10 kΩ or higher
|
Relay
| Tester Connection
|
Condition
|
Specified Condition
|
| 3 - 5
|
Auxiliary battery voltage not applied between terminals 1 and 2
|
10 kΩ or higher
|
| Auxiliary battery voltage applied between terminals 1 and 2
|
Below 1 Ω
|