Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM WARNING SWITCH
RM37A0E _54 Brake _086869 BRAKE SYSTEM (OTHER) _0420928 VACUUM WARNING SWITCH A

BRAKE SYSTEM (OTHER)  VACUUM WARNING SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during vacuum warning switch assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: Learning can also be performed using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 1.REMOVE BATTERY

Hide 83390H 2.REMOVE VACUUM WARNING SWITCH ASSEMBLY

a.
C425760

Disconnect the connector from the vacuum warning switch assembly.


b.

Remove the vacuum warning switch assembly from the brake booster assembly.


c.

Remove the grommet from the brake booster assembly.