Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR (for 4WD/AWD)
RM37A0E _54 Brake _086868 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0420933 REAR SPEED SENSOR(for 4WD/AWD) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR(for 4WD/AWD)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.INSTALL REAR SKID CONTROL SENSOR

a.

Install the rear skid control sensor to the rear axle carrier sub-assembly with the bolt.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:
·

Keep the tip of the rear skid control sensor and installation hole free of foreign matter.

·

Firmly insert the rear skid control sensor body into the rear axle carrier sub-assembly before tightening the bolt.

·

After installing the rear skid control sensor to the rear axle carrier sub-assembly, make sure that there is no clearance between the rear skid control sensor stay and rear axle carrier sub-assembly. Also make sure that no foreign matter is stuck between the parts.




b.

Connect the No. 2 parking brake wire assembly connector to the rear skid control sensor.


Hide 2.INSTALL REAR WHEEL