Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › YAW RATE AND ACCELERATION SENSOR
RM37A0E _54 Brake _086868 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0420934 YAW RATE AND ACCELERATION SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  YAW RATE AND ACCELERATION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during yaw rate sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Removal/installation of yaw rate sensor
·

Perform "Reset Memory"

·

Perform calibration (linear solenoid valve offset learning, SM solenoid valve offset learning, brake pedal stroke sensor assembly zero point calibration, system information memorization, and yaw rate and acceleration sensor zero point calibration).


·

DTCs are stored

·

ABS warning light illuminates

·

Brake system warning light (yellow indicator) illuminates

·

Slip indicator light illuminates

·

VSC disabled or malfunctions


(Click here)

PROCEDURE

Hide 89183B 2.REMOVE YAW RATE SENSOR

a.
C425592

Disconnect the connector from the yaw rate sensor.


b.

Remove the 2 nuts and yaw rate sensor.

NOTICE:
·

Do not drop the yaw rate sensor.

·

If the yaw rate sensor is dropped, replace it with a new one.