Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH
RM37A0E _54 Brake _086868 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0420937 VSC OFF SWITCH G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VSC OFF SWITCH  INSPECTION  


PROCEDURE

Hide 84988L 1.INSPECT VSC OFF SWITCH

a.
C425587C01
2.51,1.771 2.26,1.365 true 1.906,1.781 2.042,1.375 true 1.552,1.792 1.427,1.365 true 0.927,1.781 1.229,1.365 true 0.073,0.073 0.49,0.406 0.417,0.333 10 false *a 1.531,1.792 1.802,2 0.271,0.208 10 false + 1.854,1.792 2.125,2 0.271,0.208 10 false E 2.448,1.792 2.823,2.021 0.375,0.229 10 false ILL- 0.823,1.792 1.198,2.01 0.375,0.219 10 false ILL+
*a Component without harness connected
(VSC OFF Switch)


Make sure that there is no looseness in the locking part and the connecting part of the connector.

OK:

The connector is securely connected.



b.

Disconnect the VSC OFF switch connector.


c.

Check both the connector case and the terminal for deformation and corrosion.

OK:

No deformation or corrosion.



d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
5 (+) - 2 (E) Switch pushed Below 1 Ω
5 (+) - 2 (E) Switch not pushed 10 kΩ or higher



e.

Connect a positive (+) lead from the auxiliary battery to terminal 6 (ILL+) and a negative (-) lead to terminal 1 (ILL-) of the VSC OFF switch connector.

OK:

The VSC OFF switch illumination illuminates.


If the result is not as specified, replace the VSC OFF switch.