Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE PEDAL LOAD SENSING SWITCH
RM37A0E _54 Brake _086868 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0420939 BRAKE PEDAL LOAD SENSING SWITCH G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE PEDAL LOAD SENSING SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT BRAKE PEDAL LOAD SENSING SWITCH (BRAKE PEDAL SUPPORT ASSEMBLY)

a.

Make sure that there is no looseness in the locking part and the connecting part of the connector.


b.

Disconnect the brake pedal load sensing switch (brake pedal support assembly) connector.


c.

Check both the connector case and the terminal for deformation and corrosion.

OK:

No deformation or corrosion.


NOTICE:
·

Do not remove the brake pedal load sensing switch from the brake pedal support assembly.

·

When there is a malfunction in the brake pedal load sensing switch, replace the brake pedal support assembly.




d.

Measure the resistance according to the value(s) in the table below.

C406487C01
5.865,1.635 6.094,1.313 6.094,1.313 6.26,1.313 false 1.292,1.604 1.531,1.74 1.531,1.74 1.698,1.74 false 1.188,1.74 1.635,2.167 1.635,2.167 1.802,2.167 true 1.792,3.927 2.24,4.354 2.24,4.354 2.406,4.354 true 0.854,4.323 1.021,4.323 1.021,4.323 1.438,3.906 true 6.323,1.229 6.604,1.469 0.281,0.24 10 false *1 2.49,4.271 3.094,4.604 0.604,0.333 10 false FSW+ 1.75,1.656 2.063,1.813 0.313,0.156 10 false *a 1.854,2.094 2.167,2.25 0.313,0.156 10 false *b 1.531,3.167 1.844,3.323 0.313,0.156 10 false *c 0.406,4.229 1.01,4.563 0.604,0.333 10 false FSW-
*1 Brake Pedal Load Sensing Switch - -
*a Brake pedal released (ON) *b Brake pedal depressed (OFF)
*c Component without harness connected
(Brake Pedal Load Sensing Switch)
- -


Standard Resistance:
Tester Connection Condition Specified Condition
1 (FSW-) - 2 (FSW+) Brake pedal load sensing switch off (Brake pedal depressed) 950 to 1050 Ω
Brake pedal load sensing switch on (Brake pedal released) 203 to 223 Ω


If the result is not as specified, replace the brake pedal support assembly.