The skid control ECU (brake actuator assembly) receives signals from the steering angle sensor via CAN communication.
When a malfunction occurs in the communication line to the steering angle sensor, U012687 is output.
If a DTC related to the CAN communication line is output, first troubleshoot the CAN communication line.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C05262A | Steering Angle Sensor Module Signal Stuck In Range | Normal communication between the skid control ECU and the steering angle sensor and abnormal steering angle sensor zero point. | ·
Steering angle sensor ·
Wire harness and connector |
Inspect the fuses for circuits related to this system before performing the following procedure.
Clear the DTCs.
Turn the ignition switch off.
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch to ON and check that no CAN communication system DTCs are output.
Drive the vehicle at a speed of 35 km/h (22 mph) and turn the steering wheel to the right and left.
Check that no speed sensor and/or yaw rate sensor (airbag sensor assembly) DTCs are output.
| Result | Proceed to |
|---|---|
| DTC C05262A is output. | A |
| CAN communication system DTCs are output. | B |
| Speed sensor and/or yaw rate sensor (airbag sensor assembly) DTCs are output. | C |
If a speed sensor, or the yaw rate sensor (airbag sensor assembly) is malfunctioning, DTCs for the steering angle sensor may be stored even though the steering angle sensor is normal.
If speed sensor and/or yaw rate sensor (airbag sensor assembly) DTCs are output simultaneously, repair these malfunctions and then inspect the steering angle sensor.
A
B
C
| *a | Front view of wire harness connector
(to Steering Angle Sensor) |
Turn the ignition switch off.
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
The connector is securely connected.
Disconnect the H57 steering angle sensor connector.
Check both the connector case and the terminals for deformation and corrosion.
No deformation or corrosion.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H57-9 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Steering Angle Sensor) |
Turn the ignition switch off.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H57-4 (BAT) - Body ground | Always | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H57-6 (ESS) - Body ground | 1 minute or more after disconnecting the cable from the negative (-) auxiliary battery terminal | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG